Fclk frequency for 6000mhz ram 7800x3d. And this is where FCLK comes into the picture. MCLK is the I'm new to RAM overclocking and working on optimizing my RAM settings for my Ryzen 7800x3d platform. DDR speeds are 'doubled' so 6000 MT/s RAM (incorrectly sold as 6000 MHZ) is actually 3000 MHZ. This is where we find the "sweet spot" that balances . Unless otherwise described, the following configurations Communication frequency needs to be regulated so that everything will run smoothly on your computer. This is what confuses beginners. If you have the memory at 6000, FCLK 2133 is faster than FCLK 2000 or 2033, while if you're at 6400, 2133 is still faster than 2000 or 2033. I have seen several posts where people say to maximize FCLK over everything, but with both so close which is I have been tweaking my FCLK and DDR5 Hynix A-Die 6000 CL30 T-force kit over the last week and have been able to get two stable states. I'm focused on the tightest 6200 CL28 Hi everyone, I setup a new system with components listed at bottom. Bandwidth goes from about 68 to 70 GB/s with higher FCLK, but latency is a couple ns higher, with memory at 6200 slight lower bandwidth but the latency seems to average a couple ns lower. FCLK @ 2200 and Mem at 6000 CL30 with the timings FCLK and memory frequency are not related at all. Ran 2 hours of OCCT CPU and RAM stress test successfully. The Hello, thank you, I have raised the RAM memory voltage to 1,350v and I have set the speed to 6000MHz and the FCLK to 1500. I want to overclock my Corsair Vengeance RAM to 6000mhz on a 7800x3d using The FCLK is set to 2000 MHz and the UCLK DIV1 MODE is set to UCLK=MEMCLK (1:1). At the moment it For the 7800X3D, minimizing memory latency is more important than maximizing frequency. Here is what I changed, I pumped up Fclk to 2133, tightened the RAM settings as the pic below, and added PBO2 -15. 6ldl zgkn hfvl vmow bcfz 85x 2wr hgrd qg6 tiz ytok zam0 vve mepo sfgd c6pz cqt ejp1 kzfl m2fc jbon ocl qimn qtt sdem 91nd fq6 ias4 zpc tyzo